User manual AEG-ELECTROLUX RF593

[. . . ] Water connection • Make sure not to cause damage to the water hoses. €¢ Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. €¢ The first time you use the appliance, make sure that there is no leakage. €¢ The water inlet hose has a safety valve and a sheath with an inner mains cable. [. . . ] It automatically adjusts the temperature and quantity of the water, the energy consumption and the programme duration. 3) This programme has a high temperature rinsing phase for better hygiene results. During the rinsing phase, the temperature stays at 70 °C for at least 10 minutes. 5) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil. This prevents the remaining food to bond on the dishes and bad odours to come out from the appliance. Information for test institutes For all the necessary information for test performance. 2 Acoustic signals The acoustic signals operate when the appliance has a malfunction, when the adjustment of the level of the water softener occurs and when the programme is completed. By default, the acoustic signals are on, but it is possible to deactivate them. Make sure that the appliance is in setting mode, refer to ‘Setting and starting a programme’. Press and hold, at the same time, button and button until the indi, 5. 1 Multitab Activate this option only when you use the combi detergent tablets. If the control panel does not show this condition, press and hold, at the same and button time, button the appliance is in setting mode. Until Cancelling the delay start while the countdown operates When you cancel the delay start, also the programme is cancelled. Press and hold, at the same time, butand button until all the ton programme indicators come on. Press and hold, at the same time, button and button until all the programme indicators come on. Make sure that there is detergent in the detergent dispenser before you start a new programme. If you do not press the on/off button, the AUTO OFF function automatically deactivates the appliance a few minutes after the end of the programme. This helps to decrease the energy consumption, Important • Let the dishes become cold before you remove them from the appliance. €¢ First remove the items from the lower basket, then from the upper basket. €¢ There can be water on the sides and on the door of the appliance. Press the delay start button again and again until the indicator of the number of hours you want to set comes on. €¢ When the countdown is completed, the programme starts. [. . . ] Press and hold, at the same time, programme button button and programme After the checks are completed, activate the appliance. 1 If the washing and drying results are not satisfactory Whitish streaks or bluish layers on glasses and dishes • The released quantity of rinse aid is too much. Stains and dry water drops on glasses and dishes • The released quantity of rinse aid is not sufficient. Dishes are wet • The programme is without a drying phase or with a low temperature drying phase. [. . . ]