User manual AEG-ELECTROLUX LUX LV1-2
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX LUX LV1-2. We hope that this AEG-ELECTROLUX LUX LV1-2 user guide will be useful to you.
Manual abstract: user guide AEG-ELECTROLUX LUX LV1-2
Detailed instructions for use are in the User's Guide.
[. . . ] Laurel, New Jersey 08054, USA 43371
G W
WARNING: Use Energizer® or DURACELL® Alkaline Batteries Only.
Energizer® is a registered trademark of Eveready Battery Company, Inc. DURACELL® is a registered trademark of The Gillette Company, Inc.
Please read all instructions carefully before beginning installation. Before removing any wiring from your existing thermostat, its wires must be labeled with their terminal designations. Ignore the color of the wires since they may not comply with any standard.
Thank you for your confidence in our product. [. . . ] A smaller swing number increases the number of cycles, so room temperature is more constant. A larger swing number decreases the number of cycles, but saves energy in most cases.
2 WIRE SYSTEM HEAT ONLY
PROGRAMMING
B
JUMPER
G
Y
W
RH
RC
O
The CAG1500 provides four independent programming periods per day for HEAT, COOL, and FAN. You can use the default programs or alter them to suit your schedule.
DEFAULT ENERGY STAR® TEMPERATURE PROGRAM
As supplied from the factory, the following ENERGY STAR® approved program will be used for temperature control in RUN mode. This program and all other software settings may be restored to their default values via a SOFTWARE RESET.
SWING SETTING
1. Rotate the dial to the RUN position to finish.
EASY PROGRAMMING WITH LUX SPEED DIAL®
HEAT
24 VOLT HEAT TRANSFORMER
120 V CA
3 WIRE SYSTEM HEAT ONLY (3rd WIRE FOR FAN)
G G G G G G G G G G G
Small elegant design Exclusive LUX Speed Dial® EL Illuminated Display Comprehensive Graphical Filter Monitor 7 Day Programming Energy Star Compliant 4 Periods Per Day Independent Fan Program Programmable (minimum) Fan Duty Cycle Nonvolatile Memory For All Programs And Settings Temporary Temperature Override
G G G G G G G
Temperature Hold Keyboard Lockout F/C Temperature Display 12/24 Hr Clock Display Adjustable Temperature Differential / Cycle Rate User Temperature Offset / Calibration 5/2 minute selectable minimum Run/Off time provides short cycle and compressor protection
G
Y
W
RH
RC
B
JUMPER
O
PERIOD HEAT MODE COOL MODE Morning 6:00 AM 70°F (21°C) 6:00 AM 78°F (26°C) 8:00 AM 62°F (17°C) 8:00 AM 85°F (29°C) Day Evening 6:00 PM 70°F (21°C) 6:00 PM 78°F (26°C) 10:00 PM 62°F (17°C) 10:00 PM 82°F (28°C) Night
TEMPERATURE CALIBRATION
1. Use UP/DOWN keys to adjust the thermostats calibration by as much as ± 5°F (± 3°C).
EDITING HEAT OR COOL PROGRAMS
You can change any preset times and/or temperatures to suit your schedule for each day of the week. The four periods each day are Morning(MORN), Day, (DAY) Evening(EVE), and Night(NITE).
LOCK
To prevent tampering, press NEXT NEXT NEXT HOLD. This sequence of keys will lock and unlock the set temperature, programs and other settings. When the keys are locked, a padlock icon will be visible above the time and temperature display. The Lock will be disabled after a Hardware Reset.
MO NITE
FAN
HEAT
24 VOLT HEAT TRANSFORMER
120 VAC
WEEKDAY PROGRAMMING
1. You will see the display shown here:
PROGRAM MO MORN START AT
AM
1:30 70 120
HEAT
SET
FILTER
3 WIRE SYSTEM COOL ONLY
G
Y
W
RH
RC
B
JUMPER
O
6:00 70
HEAT
SET
SETUP OPTIONS
JUMPER SETTINGS
There are four jumpers, each controls a setting depending on its position.
CAUTION
The CAG1500 is protected against normal static electric discharges. Install two new Energizer or DURACELL "AA" size alkaline batteries in the battery compartment. Hang the top of the unit by the tabs at the top corners of the base, then snap the bottom of the unit into place. If the body does not snap into place easily, remove the body, re-hang it from the tabs and try again. Turn the power back on to your heating and/or air conditioning system. If this is the first time you are installing batteries, the thermostat will display "SUN 12:00 AM". Within 90 seconds the thermostat will begin to display the room temperature alternately with the time. To correct the display, see "Setting the TIME and DAY, " after you set the programs.
G
Y
W
ADD JUMPER
RH
RC
B*
JUMPER
O*
MON
DAY EVE NIGHT MORN DAY EVE NIGHT MORN
FRI
TUES
SAT
FAN
HEAT PUMP
24 VOLT HEAT TRANSFORMER
120 VAC
CHANGEOVER HEAT
CHANGEOVER COOL
WED
DAY EVE NIGHT
SUN
CAUTION
Read instructions carefully before removing any wiring from existing thermostat. G When removing wires from their terminals, ignore the color of the wires since they may not comply with any standard.
G
*"B" OR "O" BUT NEVER BOTH
CLEAN AIR CYCLE. Install two new Energizer or DURACELL "AA" size alkaline batteries at this time. To do this hang the top of the unit by the NOTE tabs on the base, then snap the bottom Remove sticker from display. If the body does not snap into place easily, remove the body, re-hang it from the tabs and try again. [. . . ] You will see a display FAN MORN similar to that shown here: START AT 2. The start time for the displayed period will flash to show that this may AM be changed. The beginning of that period may not be any closer to the beginning of the next period than one 15 minute increment. When all the periods for a day have been set, the start time for the next morning will be flashing so that it may be edited. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX LUX LV1-2
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX LUX LV1-2 will begin.