User manual AEG-ELECTROLUX L76285FL

[. . . ] L 76285 FL L 76482 FL EN User manual 2 www. aeg. com CONTENTS 1. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. aeg. com Register your product for better service: www. aeg. com/productregistration Buy Accessories, Consumables and Original spare parts for your appliance: www. aeg. com/shop CUSTOMER CARE AND SERVICE We recommend the use of original spare parts. When contacting Service, ensure that you have the following data available. [. . . ] Different causes can change the data: the quantity and type of laundry, the water and ambient temperature. ENGLISH 13 Programmes Load (kg) Energy consumption (kWh) Water consumption (litre) Approxi- Remain- Remainmate ing ing promoismoisgramme ture ture duration (%)1) (%)1) (miL 76285 L 76482 nutes) FL FL 168 164 110 91 58 53 53 35 35 30 52 52 35 35 30 Cottons 60 °C Cottons 40 °C Synthetics 40 °C Delicates 40 °C Wool/Hand wash 30 °C Standard 60 °C cotton Standard 60 °C cotton Standard 40 °C cotton 8 8 4 4 2 1. 60 1. 00 0. 60 0. 70 0. 35 72 72 50 60 57 Standard cotton programmes 8 4 4 0. 90 0. 65 0. 49 46 45 44 208 156 156 53 53 53 52 52 52 1) At the end of spin phase. Off Mode (W) 0. 48 Left-On Mode (W) 0. 48 The information given in the charts above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. 7. BEFORE FIRST USE 1. To activate the drain system, put 2 litre of water in the main wash compartment of the detergent dispenser. Put a small quantity of detergent in the main wash compartment of the detergent dispenser. Set and start a programme for cotton at the highest temperature without laundry. USING THE APPLIANCE 1. Open the water tap. 2. Connect the mains plug to the mains socket. 14 www. aeg. com 3. Press button 1 to activate the appliance. Set and start the correct programme for the type of laundry and soil. 2. Put the laundry in the drum, one item at a time. Close the door. 8. 1 Loading the laundry 1. Open the appliance door. There is a risk of water leakage or damage to the laundry. 8. 2 Filling the detergent and additives The detergent compartment for the prewash phase and the soak programme. Add the detergent for prewash and soak before the start of the programme. If you use a liquid detergent, put it immediately before you start the programme. This is the maximum level for the quantity of liquid additives. ENGLISH 15 The compartment for the stain remover. Put the product in the compartment and set the stain function before you start the programme. Flap for powder or liquid detergent Turn it (up or down) in the correct position to use powder or liquid detergent. Always obey the instructions that you find on the packaging of the detergent products. Check the position of the flap 1. Pull out the detergent dispenser until it stops. Press the lever down to remove the dispenser. 3. To use powder detergent, turn the flap up. 4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid detergent than the limit showed in the flap. Make sure that the flap does not cause a blockage when you close the drawer. 2. 8. 3 Setting and starting a programme 1. The related programme indicator comes on. The indicator of button 4 flashes with red colour. To change the temperature and/or the spin speed, press the related buttons. The indicator of the set function comes on or the display shows the related symbol. 5. 8. 6 Change a function You can change only some functions before they operate. 1. Press button 4 . The drain pump can operate for a short time when the appliance fills water. 8. 7 Set the delay start 1. Press button 5 again and again until the display shows the number of minutes or hours. [. . . ] Follow the instructions supplied with the kit. 12. 2 Unpacking 1. Use the gloves. Remove the polystyrene packaging materials. 4. Remove the internal film. 5. Open the door. Remove the polystyrene piece from the door seal and all the items from the drum. 6. Put one of the polystyrene packaging elements on the floor behind the appliance. Pull up the appliance in vertical position. 1 2 9. Remove the power supply cable and the drain hose from the hose holders. 10. [. . . ]