User manual AEG-ELECTROLUX GS60BI220

[. . . ] Obey the safety instructions from the detergent manufacturer to prevent burns to eyes, mouth and throat. Do not use the appliance for other uses to prevent injury to persons and damage to property. Only use the appliance to clean accessories that are applicable for dishwashers. Do not put flammable products or items that are wet with flammable products in, near or on the appliance. [. . . ] Keep dishwasher detergents in a safe area and out of children touch. Do not keep the appliance door open when there is detergent in the detergent dispenser. Fill the detergent dispenser only before you start a washing programme. 1) After you fill the container, the salt indicator can stay on for some hours. This does not have an unwanted effect on the operation of the appliance. 1) When the salt container and/or the rinse aid dispenser are empty, the related indicators do not come on while a washing programme operates. After ten minutes from the end of the washing programme, the AUTO OFF function automatically deactivates the appliance. Press this button again and again to delay the start of the washing programme from 1 to 24 hours. The dishes can be wet at the end of the programme when you open the appliance door. Press one of these buttons again and again until the indicator of the washing programme comes on. With these buttons you can: The appliance must be in setting mode for these operations: · ­ It is necessary to cancel the programme or the delay start to go back to the setting mode. Be sure that the set level of the water softener agrees with the water hardness in your area. If you use the combi detergent tablets ('3 in 1', '4 in 1', '5 in 1'), use the multitab function (refer to 'Multitab function'). Adjust the level of the water softener if this does not agree with the water hardness in your area. Contact your local water authority to know the water hardness in your area. Press and hold function button (B) and function button (C) at the same time until the programme indicators above function buttons (A), (B) and (C) flash. Use of dishwasher salt If the water softener is set electronically to the level 1, the salt indicator stays off. Fill the salt container with 1 litre of water (only for the first time you fill with salt). It is correct that water comes out from the salt container when you fill it with salt. To help the environment, do not use more than the correct quantity of detergent. If the washing programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. If you use the detergent tablets, put the tablet in the detergent dispenser 1 . [. . . ] The filters are dirty or not asMake sure that the filters are sembled and installed correctly. There are streaks, whitish stains, or a bluish layer on glasses and dishes. The washing programme was without a drying phase or with a decreased drying phase. Press and hold function button (B) and function button (C) at the same time until the programme indicators above function buttons (A), (B), and (C) start to flash. [. . . ]