User manual AEG-ELECTROLUX FAVORIT 65402 VI

[. . . ] Com SAFETY INSTRUCTIONS Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. €¢ The water inlet hose has a safety valve and a sheath with an inner mains cable. €¢ Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge use the appliance. [. . . ] Activating the multitab option Activate or deactivate the multitab option before the start of a programme. You cannot activate or deactivate this option while a programme operates. If you stop to use the combi detergent tablets, before you start to use separately detergent, rinse aid and dishwasher salt, do these steps: 1. Make sure that the salt container and the rinse aid dispenser are full. Start the shortest programme with a rinsing phase, without detergent and without dishes. During the rinsing phase, the temperature stays at 70 °C for 10 to 14 minutes. aCOUSTIC SIGNALS The acoustic signals operate in these conditions: • The programme is completed. €¢ The level of the water softener is adjusted electronically. Make sure that the set level of the water softener agrees with the water hardness in your area. Contact your local water authority to know the water hardness in your area. If you use the combi detergent tablets, activate the multitab function. Be sure that these tablets are applicable to the water hardness in your area. ADJUSTING THE WATER SOFTENER Hard water contains a high quantity of minerals that can cause damage to the appliance and bad washing results. The dishwasher salt keeps the water softener clean and in good conditions. It makes sure that the water softener uses the correct quantity of dishwasher salt and water. Com Manual adjustment Turn the water hardness dial to the position 1 or 2. Make sure that the appliance is in setting mode, refer to ‘SETTING AND STARTING A PROGRAMME’. Press and hold buttons (4) and (5) at the same time until the indicators of buttons (3), (4) and (5) flash. The rinse aid, during the last rinsing phase, helps to dry the dishes without streaks and stains. M AX + 4 3 2 1 - C D Press the release button (D) to open the lid (C). Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. [. . . ] The quality of the detergent Try a different brand of decan be the cause. €¢ Activate the rinse aid dispenser and use the rinse aid together with the combi detergent tablets. HOW TO ACTIVATE THE RINSE AID DISPENSER The activation of the rinse aid dispenser can occur only with the multitab option activated. Make sure that the appliance is in setting mode, refer to ‘Setting and starting a programme’. [. . . ]