User manual AEG-ELECTROLUX EXD15DN3W

[. . . ] Your dehumidifier must be plugged directly into a properly grounded and polarized three-prong receptacle. Lf the wall receptacle you intend to use will not accept a three-prong plug, or if you are not sure the outlet is adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician install the proper outlet according to the National Electrical Code and applicable local codes and ordinances. Always grip the plug firmly and pull straight out from the receptacle. Do not insert or place fingers or objects into the air discharge area or front grille of the unit. [. . . ] It is recommended you leave the unit running in the CONTINUOUS setting for the first three or four days until the sweating and dampness odors have stopped. After a few days when the Relative Humidity has declined, press the HUMIDIor buttons to choose a value TY between 35% to 85%, so the room is kept at a comfortable humidity. pressor buttons will change ing the the humidity selection in 5% increments. After you have set the desired humidity, the readout will display the actual room humidity. If at any time you want to return to the CONTINUOUS butMode, pressing the HUMIDITY ton will lower the Relative Humidity through the 5% increments until the display reads CO. You can also use the FAN SPEED button to change the fan speed to HIGH or LOW. The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0. If the unit is running, then selecting Timer will turn the unit off in the hours that will be set (Delay Stop). If the unit is off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start). TIMER setting: , then adFirst press TIMER button just timer setting, by tapping or holding or button to change the dethe lay timer at 0. 5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. for the Delay Start , the fan speed and humidity maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER button again at any time will stop the TIMER function. The Delay Start/Stop Feature will work until the unit either starts or stops. ­ Before entering TIMER setting, make sure power is being supplied to the unit. ­ Before entering TIMER setting, make or sure pressing HUMIDITY button sets one desired room humidity first. At this time refer to the care and cleaning section to remove and clean the filter. Once the filter has been cleaned and replaced, simply press the FILTER butto extinguish the light. [. . . ] Unit will not operate satisfactorily if the room temperature is below 5°C (41°F). The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]