User manual AEG-ELECTROLUX ESI6200LOX

[. . . ] Children must get supervision to make sure that they do not play with the appliance. ⷠKeep children away from the appliance when the door is open. installation · Make sure that the appliance is not damaged because of transport. Do not use the appliance: ­ if the mains cable or water hoses are damaged, ­ if the control panel, worktop or plinth area are damaged, that you can get access to the inner side of the appliance. [. . . ] Rinse aid makes it possible to dry the dishes without streaks and stains. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the subsequent washing programme. You can set the rinse aid dosage between position 1 (lowest dosage) and position 6 (highest dosage). Only use the appliance for household utensils that are applicable for dishwashers. Do not use the appliance to clean objects that can absorb water (sponges, household cloths, etc. Before you load cutlery and dishes, do these steps: ­ Remove all food remainings and debris. While you load cutlery and dishes, do these steps: ­ Load hollow items (e. ­ Make sure that water does not collect in the container or in a deep base. ­ Make sure that cutlery and dishes do not lie inside one another. ­ Make sure that cutlery and dishes do not cover other cutlery and dishes. Plastic items and pans with non-stick coatings can keep water droplets. ­ The phase indicator light or lights for the washing programme come on. ­ When the programme starts, only the indicator light of the phase in progress stays on. Fill the detergent dispenser with detergent before you set a new washing programme. Press the delay start button until the display shows the necessary delay start time for the washing programme. When the countdown is completed, the washing programme automatically starts The phase indicator light of the phase in progress comes on. Do not open the door during the countdown to prevent interruption of the countdown. When you close the door again, the countdown continues from the point of interruption. End of the washing programme Switch off the appliance in these conditions: · For better drying results, keep the door ajar for some minutes before you remove the dishes. Standby mode If you do not switch off the appliance at the end of the washing programme, the appliance automatically goes into standby mode. Three minutes after the end of the programme, all indicator lights go off and the digital display shows one horizontal bar. Prewash Main wash up to 45°C or 70°C 1 or 2 intermediate rinses Final rinse Drying Main wash up to 60°C Final rinse Prewash Main wash up to 70°C 2 intermediate rinses Final rinse Drying Prewash Main wash up to 50°C 1 intermediate rinse Final rinse Drying 1 cold rinse (to prevent food scraps to bond). [. . . ] The internal diameter must not be smaller than the diameter of the hose. if you connect the water drain hose to a trap spigot under the sink , remove the plastic membrane (A). If you do not remove the membrane, remaining food can cause a blockage in the drain hose spigot The appliance has a security feature to prevent that dirty water goes back into the appliance. If, the spigot of the sink has a 'non-return valve', this valve can cause the appliance to drain incorrectly. [. . . ]