User manual AEG-ELECTROLUX ESF67071WR

[. . . ] You MUST read it carefully before installing or using the appliance. q Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Always insist on genuine spare parts. Disposal Dispose of the dishwasher packaging material correctly. Plastic parts are marked with standard international abbreviations: >PE< for polyethylene, e. g. [. . . ] Using no more then the correct amount of detergent contributes to reducing pollution. Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Use of "3 in 1" combi detergent tablets General advice These products are tablets with combined detergent/rinse-aid and salt functions. Before using these products you should first check that the water hardness in your supply is compatible with the use of these products as per the detergent manufacturers (on the product packaging). These products should be strictly used according to the detergent manufacturers instructions. Do not place the tablets in the tub or in the cutlery basket as this will result in poorer wash results. If you encounter problems when using 3 in 1 products for the first time then please contact the detergent manufacturers care line (the telephone number is given on the product packaging). Fill with detergent (Detergent dispenser type A) 1. The marking indicates the dosing levels: 20 = approximately 20 ml of detergent 30 = approximately 30 ml of detergent Special advice When using combination products, the rinse-aid and salt indicators are no longer useful. It may be helpful therefore to switch the rinse aid off - please note that only some dishwashers have this facility - and select the lowest possible setting for water hardness. If you decide to turn back to the use of the standard detergent system we advise that you: q Refill both the salt container and rinse aid dispenser. Switch the water hardness setting to the highest possible position and run a normal washing programme without a load. Readjust the water hardness setting again according to the hardness of the water in your area. DE19 DE22 q 3. During the countdown, the indicator light of the selected programme and the indicator light of the number of hours to the start of the programme will remain illuminated. Once the delay start has elapsed the programme will start automatically, the indicator lights for delay start turn off and the indicator light of the phase underway illuminates. Cancelling the "delay start" It is possible to cancel a countdown in progress or before it starts, simply pressing the delay start push button until the indicator lights corresponding to the delay start hours are off. In this case the selected washing programme will start automatically after 6 seconds. 5. Setting and starting the programme Press the push button corresponding to the required programme (see "Washing programmes" chart). The indicator light corresponding to the programme illuminates and the phase indicator lights foreseen for that programme start flashing. It is possible to change the programme selection simply pressing the push button of another programme within 6 seconds. Once the programme has started the phase indicator lights will turn off except for the phase under way. 8. End of the washing programme The dishwasher will automatically stop and the end of programme phase indicator light will illuminate. The dishwasher has finished the programme only when the end of programme indicator light is illuminated. If you do not wait for the end of the programme it will not be possible to start a new programme until the previous programme has been cancelled. (For instructions on how to cancel a programme see the corresponding instructions). [. . . ] Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. If the dishwasher is later used as a free-standing appliance, the original worktop must be re-mounted. The plinth on free-standing appliances is not adjustable. Levelling Good levelling is essential for correct closure and sealing of the door. [. . . ]