User manual AEG-ELECTROLUX ESF6637RLW

[. . . ] € The water inlet hose has a safety valve and a sheath with an inner mains cable. € Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge use the appliance. They must have supervision or instruction for the operation of the appliance by a person who is responsible for their safety. € Keep children and pets away from the appliance door when it is open. [. . . ] € If the option is not applicable to the programme, the related indicator flashes for some seconds and then stays off. 1 Multitab Activate this option only when you use the combi detergent tablets. € Press Option again and again until the multitab indicator comes on. If you stop to use the combi detergent tablets, before you start to use separately detergent, rinse aid and dishwasher salt, do these steps: 1. Make sure that the salt container and the rinse aid dispenser are full. Start the shortest programme with a rinsing phase, without detergent and without dishes. During the rinsing phase, the temperature stays at 70 °C for 10 to 14 minutes. Press the ExtraHygiene touchpad: • If the option is applicable to the programme, the related indicator comes on. € If the option is not applicable to the programme, the related indicator flashes for some seconds and then stays off. Make sure that the set level of the water softener agrees with the water hardness in your area. Contact your local water authority to know the water hardness in your area. Manual adjustment Turn the water hardness dial to the position 1 or 2. Press and hold Delay and Start at the same time until the indicators (A), (B) and (C) flash. 3 Filling the rinse aid dispenser A B Press the release button (D) to open the lid (C). Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. M AX + 4 3 2 1 - C D You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 (highest quantity). Make sure that the appliance is in setting mode, refer to ’SETTING AND STARTING A PROGRAMME’. Set and start the correct programme for the type of load and the degree of soil. If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. [. . . ] 1 If the washing and drying results are not satisfactory Whitish streaks or bluish layers on glasses and dishes • The released quantity of rinse aid is too much. Stains and dry water drops on glasses and dishes • The released quantity of rinse aid is not sufficient. Activating the rinse aid dispenser with the multitab function activated 1. Press and hold Delay and Start at the same time until the indicators (A), (B) and (C) flash. [. . . ]