User manual AEG-ELECTROLUX ESE5608TA

[. . . ] 2. 4 Push the TIMER button and the remote controller will show the last set time for the STOP operation and the signal "h" will be shown on the display panel. 2. 5 Push the TEMP button ( or ) to set the time you want to stop the operation. 2. 6 After setting the TIMER there will be a one-half second delay before the remote controller transmits the signals to the Air Conditioner. Then after approximately another 2 seconds, the set temperature will re-appear on the digital display. [. . . ] Set the STARTING & STOPPING time 3. 1 Please press the CANCEL button to cancel any former settings. 3. 2 Push the TIMER button and the remote controller will show the last set time for START operation and the signal "h" will be shown on the display panel. 3. 3 Push the TEMP button ( or ) to set the time you want to start the operation. 3. 4 Push the TIMER button and the remote controller will show the last set time for STOP operation and the signal "h" will be shown on the display panel. 3. 5 Push the TEMP button ( or ) to set the time you want to stop the operation. 3. 6 After setting the TIMER there will be a one-half second delay before the remote controller transmits the signal to the Air Conditioner. Then, after approximately another 2 seconds , the set temperature will re-appear on the digital display. ! ~ Performance Features 1. HEAT(For Heat pump models only)) Features of the Remote Controller AUTO COOL DRY HEAT FAN HIGH MED LOW TEMP 1 MODE ON/OFF FAN 7 2 SWING ECONOMY TIMER 8 9 10 RESET LOCK 3 4 5 6 DIGITAL DISPLAY CANCEL NOTE R 11 12 1. That is the time set is based on the delay of the current time. Fig. If the AUTO mode is not comfortable , you may manually override the settings by using COOL, DRY, HEAT( HEAT PUMP models only), or FAN ONLY modes. Then, after approximately another 2 seconds , the set temperature will re-appear on the digital display. 10 11 12 5 2 Names and Functions of indicators on Remote Controller Display Panel 1 2 6 5 Operating the Remote Controller Install / Replace Batteries The Remote Controller uses two alkaline dry batteries(R03/Ir03X2). To install batteries, slide back the cover of the battery compartment and install the batteries according to the directions (+and -) shown on the Remote Controller. To replace the old batteries , use the same method as mentioned above. AUTO COOL DRY HEAT 3 4 FAN HIGH MED LOW NOTE 1. When replacing batteries, do not use old batteries or a different type battery. If you do not use the remote controller for several weeks remove the batteries. Replace the batteries when there is no answering beep from the indoor unit or if the Transmission Indicator light fails to appear. 1 Fig. 2 TRANSMISSION Indicator: This indicator lights when remote controller transmits signals to indoor unit. MODE Display: Shows the current operation modes-- AUTO, COOL, DRY and HEAT. HEAT PUMP ONLY - LOCK display is displayed by pushing the LOCK button. That is, if only the starting time of operation is set, it will display the TIMER ON. [. . . ] HEAT PUMP ONLY - LOCK display is displayed by pushing the LOCK button. That is, if only the starting time of operation is set, it will display the TIMER ON. If only the turning off time of operation is set, it will display the TIMER OFF. If both operations are set, it will show TIMER ON- OFF which indicates you have chosen to set both the starting time and off time. [. . . ]