User manual AEG-ELECTROLUX EKC6051BOW

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX EKC6051BOW. We hope that this AEG-ELECTROLUX EKC6051BOW user guide will be useful to you.


AEG-ELECTROLUX EKC6051BOW : Download the complete user guide (3965 Ko)

You may also download the following manuals related to this product:

   AEG-ELECTROLUX EKC6051BOW (3786 ko)
   AEG-ELECTROLUX EKC6051BOW (3786 ko)
   AEG-ELECTROLUX EKC6051BOW (3786 ko)
   AEG-ELECTROLUX EKC6051BOW (3786 ko)

Manual abstract: user guide AEG-ELECTROLUX EKC6051BOW

Detailed instructions for use are in the User's Guide.

[. . . ] If the refrigerant circuit should become damaged: ­ avoid open flames and sources of ignition ­ thoroughly ventilate the room in which the appliance is situated It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. Make sure that the power plug is not squashed or damaged by the back of the appliance. [. . . ] ⷠThis product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. Switching off To turn off the appliance, turn the Temperature regulator to the "O" position. Turn the Temperature regulator toward lower settings to obtain the minimum coldness. ⷠTurn the Temperature regulator toward higher settings to obtain the maximum coldness. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: · room temperature · How often the door is opened · In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, durPeriods of non-operation When the appliance is not in use for long periods, take the following precautions: · If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. There are some sounds during normal use (compressor, refrigerant circulation). Let the product temperature decrease to room temperature before storage. The melting water outlet does not Attach the melting water outlet to flow in the evaporative tray above the evaporative tray. Let the product temperature decrease to room temperature before storage. [. . . ] Make sure that the distance between the appliance and the cupboard front-edge is 44 mm. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. Make sure that the clearance between the appliance and the cupboard is 4 mm. The lower hinge cover (in the accessories bag) makes sure that the distance between the appliance and the kitchen furniture is correct. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX EKC6051BOW




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX EKC6051BOW will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.