User manual AEG-ELECTROLUX EJ2803AOX

[. . . ] 3 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 - 25 Please attach sales receipt here for future reference. MAKE A RECORD FOR QUICK REFERENCE ________________________________________________ Purchase Date ________________________________________________ Electrolux Model Number ________________________________________________ Electrolux Serial Number (see picture for location) NOTE Registering your product with Electrolux enhances our ability to serve you. You can register by dropping your Product Registration Card in the mail. ©2005 Electrolux Home Products, Inc. Printed in the USA 2 Important Safety Instructions Please read all instructions before using this refrigerator. FOR YOUR SAFETY · Do not store or use gasoline, or other flammable liquids in the vicinity of this or any other appliance. [. . . ] Remove the ice storage bin and shake to loosen the cubes. 2. NEVER use an ice pick or similar sharp instrument to break up the ice. This could damage the ice storage bin and dispenser mechanism. 15 Automatic Ice and Water Dispenser PureSource TM Ice and Water Filter (some models) NOTE: If you purchased a refrigerator with a PureSource TM Ice and Water filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right back corner of the fresh food compartment. System Startup: Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section to properly fill the system with water. Changing the Filter: Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after 400 gallons of water has flowed through the ice and water dispenser (some models). Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed). To change filter: It is not necessary to turn the water supply off to change the filter. Turn the ice maker's power switch to the Off ("O") position (See illustration on page 14). It is located in the upper right front corner of the fresh food compartment. System Startup: Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section to properly fill the system with water. Changing the Filter: Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after approximately 400 gallons of water has flowed through the ice and water dispenser. Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed and bypass installed). To change filter: It is not necessary to turn the water supply off to change the filter. Turn the ice maker's power switch to the Off ("O") position (See illustration on page 14). 2. Order new filter cartridges through the dealer where you bought the refrigerator or contact the Electrolux Customer Care Center . It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the FC-100 PureSource2TM replacement cartridge. Push the Filter Release Button, located to the right of the filter cartridge, to release the filter from the housing. To minimize the possibility of the filter falling out of the housing during removal, it would be best to hold the filter as it moves out toward you. You should have a paper towel or dish cloth handy to wipe up any water that may drip out of the filter or housing. [. . . ] If it is, replace the ice & water filter cartridge. CAUSE CORRECTION Ice maker will not stop making ice. Ice maker is not separating the ice cubes. · · Move item and release wire signal arm. Remove any ice cubes that are frozen together over the wire signal arm. Discard stale ice. · · · · · · · Ice has bad odor and taste. · · · ICE DISPENSER Dispenser will not dispense ice. [. . . ]