User manual AEG-ELECTROLUX EHS60020X 68P

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX EHS60020X 68P. We hope that this AEG-ELECTROLUX EHS60020X 68P user guide will be useful to you.


AEG-ELECTROLUX EHS60020X 68P : Download the complete user guide (306 Ko)

You may also download the following manuals related to this product:

   AEG-ELECTROLUX EHS60020X 68P (297 ko)
   AEG-ELECTROLUX EHS60020X 68P (325 ko)
   AEG-ELECTROLUX EHS60020X 68P (265 ko)
   AEG-ELECTROLUX EHS60020X 68P (269 ko)
   AEG-ELECTROLUX EHS60020X 68P (348 ko)
   AEG-ELECTROLUX EHS60020X 68P (1401 ko)

Manual abstract: user guide AEG-ELECTROLUX EHS60020X 68P

Detailed instructions for use are in the User's Guide.

[. . . ] Objects that melt and things that boil over can burn onto the glass ceramic and should be removed straightaway. To avoid damaging cookware and glass ceramics, do not allow saucepans or frying pans to boil dry. Do not use the cooking zones with empty cookware or without cookware. Children's safety Small children must be kept away from the appliance. To avoid small children and pets unintentionally switching the appliance on, we recommend activation of the child safety device. General safety The appliance may only be installed and connected by trained, registered service engineers. [. . . ] Sensor field On / Off Increase settings Decrease settings Timer Lock Function To switch the appliance on and off Increasing heat setting/time Decreasing heat setting/time Timer selection Locking/unlocking the control panel Displays Display Description Cooking zone is switched off Keep warm setting Heat settings Automatic warm up function Fault Residual heat Child safety device Safety cut-out Keep warm setting is set Heat setting is set Automatic warm-up function is activated Malfunction has occurred Cooking zone is still hot Lock/child safety device is engaged Safety cut-out has been activated u - a e h l _ Residual heat indicator 1 Warning!Afkeeping food warm. 3 Residual heat can be used for melting and ter being switched off, the cooking zones need some time to cool down. Look at the residual heat indicator h . 6 Operating the appliance Switching the appliance on and off Control panel Switch on Switch off Touch Touch for 2 seconds for 1 second Display Pilot light lights up goes out /h h / none 3 After switchingoron, functionapprox. be10 seconds within a heat setting a must set, otherwise the appliance automatically switches itself off. Setting the heat setting Control panel To increase To decrease To switch off Touch Touch Touch and at the same time Indicator u to to 3 The keep warm setting u lies between and . It is used to keep food warm. Locking/unlocking the control panel The control panel, with the exception of the "On/Off" sensor field, can be locked at any time in order to prevent the settings being changed e. g. Control panel Switch on Switch off Touch Touch Display l (for 5 seconds) previously set heat setting 3 When you switch the appliance off, the locking function is automatically switched off. 7 Using the automatic warm-up function All cooking zones are equpped with an automatic warm up function When setting a heat setting using , when starting from , the cooking zone switches to full power for a certain amount of time and then automatically switches back to the heat setting set. Control panel Switch on (only when starting at ) Switch off Not used Touch Touch Touch possible heat set- Display tings to to / u to u a (after 5 seconds) to u to u 3 If during the automatic warm up a a higher 3 If there is stillh), the automatic the cooking residual heat on warm up is zone (display not performed. from to , the automatic warm up is adjusted. The length of time that the automatic warm up function operates depends on the heat setting selected. Length of the automatic warm up [min:sec] 0:30 1:00 1:40 4:50 6:30 10:10 2:00 3:30 4:30 --- 8 Using the child safety device The child safety device prevents unintentional use of the appliance. Setting the child safety device Step 1. Control panel Switch on the appliance (Do not set a heat setting) Touch Touch until the signal sounds Display/Signal Acoustic signal l Appliance switches off. The child safety device is engaged. Releasing the child safety device Step 1. Control panel Switch on the appliance Touch Touch until the signal sounds Display/Signal l Acoustic signal Appliance switches off. The child safety device is released. Overriding the child safety device The child safety device can be released in this way for a single cooking session; it remains activated afterwards. The residual heat indicator is not displaying anything The cooking zone was only on for a If the cooking zone is supposed to short time and is therefore not hot be hot, call the Customer Service Department. Let the cooking zone cool down The highest heat setting has the same power as the automatic warm up function 1. Switching off the cooking zone 2. Set the cooking zone using the sensor field Do not place any objects on the control panel The automatic warm up function is There is still residual heat on the not switching itself on cooking zone h The highest heat setting is set The heat setting was set using the sensor field Acoustic signal sounds and appli- The On/Off sensor field has been ance switches itself on and then off covered up, e. g. by a cloth again; after 5 seconds another acoustic signal sounds _ is lit Overheating protection for the cooking zone has been triggered Electronics fault Switch off the cooking zone. Switch the cooking zone on again Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, e is displayed again, call the customer service department e and number are displayed e and minus are displayed Light rays that are too strong on the Briefly shade the control panel, for control panel, for example bright example with the hand Acoustic sunlight signal sounds, appliance switches itself off Switch appliance on (again) 16 If you are unable to remedy the problem by following the above suggestions, please contact your dealer or the Customer Care Department. 1 Warning!Repairs to the appliance are only to be carried out by qualified service engineers. 3 If the appliance has been wrongly operated, Disposal 2 Packaging material Considerable danger to the user may result from improper repairs. the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. The packaging materials are environmentally friendly and can be recycled. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities. 2 Old appliance The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. W 17 Installation Instructions Safety instructions The laws, ordinances, directives and standards in force in the country of use are to be followed (safety regulations, proper recycling in accordance with the regulations, etc. ) Installation may only be carried out by a qualified electrician. The minimum distances to other appliances and units are to be observed. The cut surfaces of the worktop are to be protected against moisture using a suitable sealant. [. . . ] Stick the single-sided adhesive sealing tape provided on the underside of the hob around the outside edge ensuring that it is not stretched. After trimming the tape (allow it to overlap by 2-3 mm), press the two ends together. 1 WARNING! Risk of injury from electrical current. Loose and inappropriate plug and socket connections can make the terminal overheat. Have the clamping joints correctedly installed by a qualified electrician. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX EHS60020X 68P




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX EHS60020X 68P will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.